IÂ’d much rather have grout between my tiles than a bunch of gross junk. Set any tiles that you canÂ’t fit flush aside and use them for cuts. Water can and does get behind tile and grout, regardless of the size of the grout line.


Blog The Importance Of Sealing Your Stone And Tile Floors



Use the longest measurements that will work to get the best accuracy.


Marble Tile Installation Without Grout

When you butt tiles together, there is still a very small gap. Since you donÂ’t have a grout joint to cover this up, it is important to make sure the floor is smooth and the tiles are flush.

Tile and grout do not provide the waterproofing in a shower.

All of the new “stacked stone” type tiles would look absurd with grout lines. Measure and pop a chalk line the distance of two tiles (probably 24 inches) from one of the walls. It would also be helpful to purchase a higher-quality marble tile since the consistency among tiles will be better.

Use the straightedge to make sure the edge of the tiles are straight against the lines.

Just in the kitchens forum alone there have been many whoÂ’ve ignored my advice and gone forward with groutless installations.

Begin spreading it with the notched trowel inside the squares down one of the walls.

Continue measuring and popping lines the same distance all the way across the room. My sister-in-law redid her bath and had limestone installed in the shower area, but without grout.

You will be butting the tiles up against each other, so there isnÂ’t any room to work out problems encountered in the grout joints, as would normally be the case. Cracked tile, broken drill bits and sloppy-looking fixture installations?

There can be very slight differences in the thickness of tiles. Do the same from the wall that is perpendicular, and you have determined to be square. Is this a wise thing to do and how do you keep the water from getting onto the wallboard behind the tiles. Use your fingers to press the tiles into the thinset, making sure that adjacent edges are smooth. As an example, if the room is 10 by 10, measure 8 feet from the corner on one wall and make a mark. I am planning on redoing our bathroom and want to have tile installed in the shower area. In the other direction, work in small sections to make sure you arenÂ’t getting out of square.

Continue working your way across the floor, using your grid lines to make sure the tiles are square and straight. In that case, pop lines in one direction and use it to keep the tiles square and straight.


How to lay marble tile in a bathroom remodel.



Another reason not to do it is that many tiles are not exactly the same size, and they will not line up properly. This means that if you measure and mark out one wall from the corner any multiple of 3 and the other wall any multiple of 4, the distance between the two marks will be exactly the multiple of 5 if the corner is square. IÂ’ve seen pictures of floors (not shower floors, just floors) where it looks like stone tile is butted up against each other, is that just really small grout joints?

Source:

Source:
genaTiles
IÂ’d much rather have grout between my tiles than a bunch of gross junk. Set any tiles that you canÂ’t fit flush aside and use them for cuts. Water can and does get behind tile and grout, regardless of the size of the grout line. Blog The Importance Of Sealing...